Freikometer version 5 (FM v5) connector for LED, speakers, and power. Inside view of 5 pin DIN female before casingenlarge 78kbprint 3130kb
5 pin DIN female after casingenlarge 56kbprint 2670kb
5 pin DIN male after casingenlarge 65kbprint 2752kb
5 pin DIN female after hood is put onenlarge 56kbprint 2791kb
Inside of connector wall on chassis. Wiring is run under aux boardsenlarge 98kbprint 4128kb
Inside of connector side of chassis (same as previous with different lighting)enlarge 98kbprint 3556kb
Front of motherboard: LED and powerbutton writes on bottom of picture and 12v wires for amp is at topenlarge 124kbprint 4246kb
Close up of connectors and chassis power buttonenlarge 82kbprint 2995kb
Connectors seen from outside of chassisenlarge 40kbprint 2593kb
Power wiring and USB addedenlarge 98kbprint 3874kb
Completed wiring of chassis. Note cable tie to hold power connector to RFID MMCX connectorenlarge 136kbprint 4758kb
Rubber feet on bottom and rubber bumpers on sides to reduce jiggle during shipping and high windsenlarge 58kbprint 3037kb
Speaker wires (4") with RS-232 male pins as ersatz speaker pins attached to 5 pin DIN femaleenlarge 62kbprint 2868kb
LED and wire on 5 pin DIN female. Note anode (long lead) is attached to red, and only one side has heat shrinkenlarge 63kbprint 2935kb
Keyswitch wiring to the 5 pin DIN female. The LED is also seen completely wrapped in heatshrink. The keyswitch is "on" when the left and right are connected. Left and right correspond to the flat sides of the keyswitchenlarge 52kbprint 2429kb
Inside view of FM with battery, solar controller, and chassisenlarge 82kbprint 2793kb
Freikometer version 5 (FM v5) connector for LED, speakers, and power. Inside view of 5 pin DIN female before casing
5 pin DIN female after casing
5 pin DIN male after casing
5 pin DIN female after hood is put on
Inside of connector wall on chassis. Wiring is run under aux boards
Inside of connector side of chassis (same as previous with different lighting)
Front of motherboard: LED and powerbutton writes on bottom of picture and 12v wires for amp is at top
Close up of connectors and chassis power button
Connectors seen from outside of chassis
Power wiring and USB added
Completed wiring of chassis. Note cable tie to hold power connector to RFID MMCX connector
Rubber feet on bottom and rubber bumpers on sides to reduce jiggle during shipping and high winds
Speaker wires (4") with RS-232 male pins as ersatz speaker pins attached to 5 pin DIN female
LED and wire on 5 pin DIN female. Note anode (long lead) is attached to red, and only one side has heat shrink
Keyswitch wiring to the 5 pin DIN female. The LED is also seen completely wrapped in heatshrink. The keyswitch is "on" when the left and right are connected. Left and right correspond to the flat sides of the keyswitch
Inside view of FM with battery, solar controller, and chassis
